Reply To: Success Printing out gaming figures.

[blinky465 17028xp 0]

I recently changed to rigid.ink and had a bit of a nightmare “dialling in” the settings to get a decent print from their pla – but once I did, the results were very impressive. The only thing I ever had trouble with (and it may be because of my auto-levelling sensor) was the first layer/skirt sticking – I either had to set the z-offset such that when it stuck on one side of the bed, it over-extruded (and went translucent) on the other, or when I had good adhesion on that side, the filament didn’t stick properly on the other.

In short, some white spirit or isopropyl alcohol to clean the bed (I used both separately and both worked as well) then a film of Tesco’s own brand glue stick on the (heated) bed and I didn’t have a problem ever again!