This was my first ever attempt at printing flat onto the build plate. I was surprised it worked at all (I angle and support almost everything, but may be less dogmatic about it now). A few did fail and a couple look a bit over/under-exposed, but they should be ok. It was also using up the last dribbles in the tank before changing from abs-like to AnyCubic standard (hence the change in colour – the paler, “blue-y” ones are abs, the “greyer” ones printed using standard) so wasn’t expecting so many to turn out so well!
I may have gone a bit too far slicing them down to make them thin enough for the lipped bases, but I guess the only way we’ll know for sure is when @lawnor posts some photos – they’re in the post already 😉
