Reply To: [unofficial weekender] It's Friday CoGs!

[horati0nosebl0wer 19649xp 0]

Lol… Thanks all. Its been busy with work so hobby has taken a backseat. As usual I’ll pop in from time to time.

@woldenspoons I’ll gladly take that complement as the first ‘reserve’ customer of these “limited edition and absolutely unreproduceable models I totally have complete intellectual property rights over with no influence other than my imagination in  the creation of”. I’d say this was on par with Steamforged and ‘The Mighty Nein’ set they put out.

@blinky465 No need to print him that big. There’s a feature in Hero Forge to actually size the minis with a relative scale manager. If I remember right he’d end up being near to 33mm tall where the rest might be about 28mm from playing around in it.

After all that I thought about the basing and the addition that Hero Forge did for putting on slotta options. I spent some time changing quite a few because I really don’t like the problem of being stuck with a certain angle unpainted. You can zenithal prime and then work glazes over quit a bit but there will always be that one spot you miss and know can never be touched because the base is in the way. I guess I’m weird like that as I build so much in general I’ll normally cut off the tab and pin the feet.