Knight test on a 0.2mm nozzle on my Ender 3 – OnTableTop – Home of Beasts of War

Knight test on a 0.2mm nozzle on my Ender 3

Supported by (Turn Off)

This topic contains 0 replies, has 1 voice, and was last updated by corvus69 5 years, 4 months ago.

Viewing 1 post (of 1 total)

Author

Posts
August 15, 2019 at 7:05 pm #1426730

corvus69
Participant

7xp

2

Hi,

I usually print using the standard stock 0.4mm nozzle that came with my Ender 3 so I decided to order and try a 0.2mm nozzle. This is the result, hope you like it. The PLA is ‘Silk Rose Gold’ (a relatively cheap Chinese brand I bought from Amazon). The Knight model is one I use as a benchmark to make sure I have my settings dialled in. Notice the stringing on the helmet, and possible over-temp at the end of his pole-arm.

Cheers,

Dave.
Author

Posts

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.