Market Garden, Cadet bolt action introduction

Supported by (Turn Off)

Project Entry by kingandcountry

HELP

November 26, 2018

Tutoring 0

Skill 0

Idea 0

3 Comments

Trying to put the airborne 6lber together and this stuff just isn't holding

3

Leave a Reply

newest oldest most voted

Admin

33947xp

avernos

that should do the job, if it’s not it may be because of mould release residue on the mini. Get it into hot water and scrub the pieces down with a toothbrush and soap. rinse it off and clean away any old glue.
Any pieces that need to be glued scuff the two surfaces to be attached with a file or some sandpaper to give you a good key and then try again.

3014xp

kingandcountry

Thanks I’ll give it a shot

11111xp

innes

I’ve had a couple of bottles of that before. Is it really thick? Mine took ages to cure on minis. Good for terrain though.
Maybe try an activator spray or sprinkle on a bit of baking powder to help it set quick.
My fave trick is to get glue on both pieces then put the tiniest pinch of blu-tak between and press them together. The glue seems to desiccate the blu-tak and gives a much stronger contact area.