Red Rocket 3D Printed
A whole lotta' roofin' going on - Part one
Once again time to start with a song. Replace Shakin’ with Roofin’ and here we go..
I may have been away for a couple of weeks but I have used that time to print out the entire roof (all 14 pieces).
As this blog would be a massive picture post I have decided to split this particular entry into 3 parts.
Below are the first batch of roofs.
I forgot to add a support at the tab on the back of the lower part. However, it still fits despite looking a bit untidy (this won’t show once the two halves have been glued together)
Next up comes the roof section that the Girder supports fit through.
Here is the third roof section.
That’s all for part one.
I’ll be back tomorrow with part two.
Catch you all later folks.
The roof… the roof… the roof is on fire 😉
That’ll come later 🙂