15mm Necromunda (onepagerules)

Supported by (Turn Off)

Project Entry by greenstufffanatic

Orlock leader with servo fist and boltgun

June 8, 2023

Tutoring 4

Skill 5

Idea 5

No Comments

Orlock leader with servo fist and boltgun

I based this sculpt off of my old orlock leader from 28mm Necromunda. I swapped out the bolt pistol for a bolt gun at some point but it was the only picture i could find. I like how the servo fist turned out and cant wait to paint it with the cables going into the arm.

The first few pics of the gallery show how I make the minis. With some 0.6mm steel wire i cut two roughly 6cm pieces off. One gets folded in half and twisted half way down using two pliers. You are left with a hoop for a head (where the first pair of flat head pliers were covering the wire). The second piece of wire is looped around some needle nose pliers. The loop here is big enough to go over the head loop of the bodies wire piece. This is attached with greenstuff and when it cures you can bend the arms accordingly.

normally this is just a blob big enough to join the loops but as the armature is so tiny it doubles as bulking for the torso. Then the rest of the mini is covered in a thin greenstuff layer. Then sculpting proper begins! Leaving bare wire for the hand that is holding a weapon. The boltgun and hand holding it are wildly large but its a cool mini.