Taking the Plunge – OnTableTop – Home of Beasts of War

Taking the Plunge

Supported by (Turn Off)

This topic has 4 replies, 4 voices, and was last updated 6 years, 11 months ago by c0d3monk33.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
April 9, 2019 at 8:52 am #1374571

wesadie1969
2729xp

0

I think the time is right and I’m going to take the plunge at the end of the month.

After a watching a tonne of reviews etc I’m going to go with the Creality CR10S Pro.

Any recommendations for good quality filament going forward?

April 9, 2019 at 9:06 am #1374572

ianska
704xp

1

If you go for either eSun or Sunlu PLA+ you won’t be disappointed. I’ve gone through about 180 rolls of the eSun stuff in grey the last 3 months and not had a single problem (touch plastic)

🙂

April 9, 2019 at 9:12 am #1374587

wesadie1969
2729xp

0

I’ll get some ordered in ready, cheers buddy.

April 9, 2019 at 9:41 am #1374604

theeuropean
141xp

1

Sunlu PLA + for me. I occasionally try other, cheaper brands but they’re either brittle, clog or aren’t consistently 1.75mm

Have fun with your CR10s Pro!

April 10, 2019 at 9:53 pm #1375474

c0d3monk33
20xp

2

Good choice. I run a couple of Creality Ender-3’s. Only problem I’ve had in a year is one of the cooling fans died, but that’s an easy replace. Creality have really lifted their game too over the year. I ordered the second Ender-3 just last month and the package is noticeably improved with part changes and various other tweaks like better firmware.
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.