OnTableTop – Home of Beasts of War

Reply To: Help with Weeping Resin

August 7, 2025 at 7:19 am #1939170

solar

2856xp

This is a common issue with 3d printing. Usually the solution is something along the lines of drilling holes into the model to let the resin leak out bearing in mind how toxic and damaging it is. Inserting an led inside the model to cure the resin (if its uv resin) or just chucking the model away. Iv done a lot of resin casting myself and with non uv resin if it has not been cured properly then unfortunately the model is essentially unfixable. On a positive side Warlord will likely replace your model as selling uncared resin is a big quality issue