Reply To: 3D Printing For A Potential Buyer

[pagan8th 14594xp 0]

Went to My Mini Factory and found loads of free samples to download and did so.

Installed Blender which is not the most intuitive software and managed to import an STL file. After some fiddling around I figure how to zoom and rotate…

Not all the STL are pre-supported so I guess I’ll need to figure that out.

Presumably I should combine STL files into a single file that I would transfer to USB and plug into a 3D printer.

Been using computers since the 1980’s and I’m computer literate, but this feels very confusing to me.