What to use to get the grease off TTCombat / Troll Trader resins? – OnTableTop – Home of Beasts of War

What to use to get the grease off TTCombat / Troll Trader resins?

Supported by (Turn Off)

Tagged: resin

This topic has 5 replies, 5 voices, and was last updated 4 years, 10 months ago by Demonsub.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
April 2, 2021 at 5:13 pm #1630802

maledrakh
11996xp

0

I regularly wash new minis in warm soapy water and scrub them down with a nailbrush to get the mould release off.

However, on some resin miniatures this is not enough and the minis are still quite greasy even after this. Examples are TTCombat / troll trader resin off their kickstarters, a few Mantic resins and all of the Shadows of Brimstone Resins. Some are greasy to the extent that the primer either is pushed away from certain spots on the model, or the primer covers, but blisters and flakes off after a while.

So the question is:

What to use to de-grease the resin minis that does not damage the resin? Does anyone have any experience with this?

April 2, 2021 at 5:38 pm #1630804

horati0nosebl0wer
20503xp

0

It might be a matter of the primer that you’re using as well. I’ve seen a few things here and there from the Reaper minis forums that the Bones line had issue with not taking spray primer. I’ve seen that rubbing alcohol has been promoted to “dry out” the mini of the material. Personally I’ve done the same with soap/water cleaning and then follow up with airbrush priming. I think it comes down to the propellant used in rattle cans that the material just doesn’t like. It makes a little sense with nylon and other polymers that don’t have a porous surface for primers to take hold.

April 2, 2021 at 6:41 pm #1630822

Demonsub
12749xp

0

Yep, same, warm soapy water and a good old scrub with a toothbrush. Never had problems with the primer flaking off but if I’m at all in doubt I use Vallejo brush on primer instead (I did this with my Reaper Bones big purple worm).

April 2, 2021 at 6:51 pm #1630830

darkvoivod
7112xp

0

I don’t quite recall what it was, but I had some mini’s that didn’t take paint after washing and primer.
My go to in such situations is isopropanol. No miniature gamer should be without. Cleans as nobodies business and is save on any plastic and resin I’ve come across.

April 5, 2021 at 9:39 pm #1632565

nighthaunter666
3309xp

1

What do you define as soapy water? a bit of hand soap probably won’t be good enough. I use diluted Fairy liquid (Brand dish washing detergent) in a spray bottle, because it’s formulated to break down grease. Spray all over, toothbrush or big paintbrush to get right into all the deep recesses. Rinse. If it’s resin, I’ll repeat that.

The last resins I had problems with, I just hadn’t washed them thoroughly enough. It was the recesses where the flaking was going on.

April 6, 2021 at 5:51 pm #1633046

Demonsub
12749xp

0

I just fill a bowl with warm warmer and a small squirt of washing up liquid. Seems to do the job well.
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.