The Tower of Prin’gl

With the FIMO elements baked, I looked at what other materials I could use to add more details.

I did cut some bricks from FIMO, to mainly be used around windows and doors, and in some areas to break up the cobblestone – like it’s been repaired or made with repurposed stone.

I also used trimmed cotton bud (q-tip) wands as window supports and detailing around the main door.

And of course, you can’t do a scratch build without some obligatory coffee stirrers!

My next challenge was to figure out how to cover the walls with a stone texture. I could cut out lots of bricks or stones from FIMO, but instead came up with an idea that is either genius or very, very daft.

Enter the split pea.

Because they have a curved side and a flat side, I thought I could just glue them and they might give a good cobbled effect, like Portchester Castle or something.

So that’s what I did.

No MDF or resin bits for me on this one, but I need to be starting on details such as windows and doors.

The curved surfaces of the two tubes make things a little tricky, so that kinda rules out card and wood (it doesn’t, but I didn’t think of a better way until after I’d finished this project !)

As I’m not great at sculpting, I turned to FIMO as I can spend time tidying it and then bake it to set it hard.

Using Affinity Studio, I quickly drew up a template for windows and doors that I could use when cutting rolled out FIMO.

I then had a go at rolling and cutting:

No problem, we’ll fix it in post!

I draped these around a mug so that they would bake with a curve on them, and FIMO baked at such a low temperature I wasn’t worried about the mug.

At the moment, these do look very rough, so am hoping that the finished result looks better!

With the two tower sections glued together, I needed to tackle the roof.

As this is a traditional wizards tower, it of course has to have a very pointy roof.

I cut a series of differently sized cones from card and shaped them into different proportions. Stuck together, they have a suitably rickety look that will hopefully still show through when tiled and painted.

Taking a Pringles tube, some other plastic tubs (hummus, Dahl etc) and a Nutella biscuits tube which also looked good, I start by stacking stuff to see if I can make some good profiles.

These look pretty good, so I use Impact Adhesive to glue them all together.

They’ll all be stuck together to make a super tall tower with a mid-height balcony.

The rules for this project are:

• must be terrain
• must be entirely scratch built
• cannot use any kits or pre-formed parts
• cannot use any pieces from miniatures.

I’ve always wanted to make a Pringles tower, so this feels like the ideal project to try that out.