Manda’s (Amachan) Gaming Table

I sprinkled on a little bit more flock with some watered down PVA and am really happy with the results now. Hopefully I can seal it in tomorrow and start work on the scenery bits.

So, I let it dry and blew air over it with a fan to reveal how bad it was.

I then diluted PVA and sprinkled it on the table where I wanted to add more and then sprinkled on more flock over there. I’m far happier with how it is looking right now.

I flocked the table and it feels like a flocking disaster….. Let’s wait until it dries and see how it turns out and fix up areas where possible.

So the table is brown again. Now just letting it dry and waiting until the flock I ordered comes in, hopefully this week.

COW TABLE!!! ? Okay, there were a couple of rough patches the filler didn’t quite get into and showed up a lot when it was painted. So I went over them with filler. I will have to sand and paint those areas tomorrow.

I sanded down the surface of my table and painted it brown. There are some brush strokes visible, but I’m not that worried about it because I’ll flock it anyway, what do you people think?

More progress on my gaming table. I sanded the surface smooth and brushed any debris off and then I used a thinned coat of filler to cover the table and fill in any last gaps. Just another pass of sanding left and then on to painting.

Right, so one thing I didn’t know that was pointed out by a couple of nice people is that I need to seal in the whole board or it will warp. So I flipped it around and coated the whole underside in an acrylic polyurethane varnish in the hope that that will be enough.