BigGrim Does Boarding Actions!
Prepping for Priming!
First up, Foamcore!
I sliced three sheets of A4 Foamcore into roughly 4 4.5cm wide strips. I produced 12 strips total. I applied doublesided tape the length of the piece and put it aside.
Next, I built the walls into 4 section lengths, using pillars and end pieces where needed. I basically made 4 identical sections out of all the pieces by three sets. I then masked off the tops of the pillar caps with 6mm Tamiya tape and attached them to the foamcore strips.
On the pieces with exposed teeth, I masked them with 18mm tamiya tape. It is nearly the perfect width to wrap around both sides. All are then attached to the foamcore.
Finally, the pillar caps have been stuck to painting sticks with double sided tape. All is now ready for a day with good weather for priming.
I should go back and do this idea so much more stable if you want single walls as line of sight blocking by keeping the card on the bottoms