Reply To: First Print (Warning: Unspectacular)

[shingen 13941xp 0]

Hi wesadie1969,

 

Good choice of printer 😉 Congrats.

 

Looking at your first print (a whistle) I think you may want to tinker a bit with fine tuning Z axis, it may be only a picture but I think your hotend maybe too high over printbed at first layer. That doesn’t look like that on your next print, but whistle’s bottom looks uneven.

 

I use older type of printbed surface, but found out the hard way that one should always use some glue stick, even when printing simple PLA.