Reply To: Printing one of the Titan Forge Patreon minis with supports already done!

[lawnor 25939xp 0]

I’m pricing up at the moment.  Best price resin seems to be £25-£26 for a 500ml bottle at the moment.  Amazon appears to be cheaper than ebay right now.  I don’t know where else to compare.  I’m looking at 2 from the same seller

Anycubic Photon, 1l standard resin with UK plug £258 after postage (Buy it now or best offer)

Says no 250ml resin, no FEP film.  I assume this means that I should expect the printer to come with a 250ml sample bottle on top of whats listed to sell with it?  Would they come with spare FEP film this model is mission, or is this missing a key component?  All in all I assume I’m better off going for this one at £11 more:

Anycubic Photon 1L standard resin, no mention of plug £269 after postage (Buy it now or best offer)

No mention of a plug, but I wouldn’t expect it to if the other listing hadn’t mentioned one.  I assume they run off the same power cables as my PC?  I have plenty of those spare so I should be covered even if it turns up with a non-uk standard cable.

 

I considered upgrading to the 1500l pack, but that increases the cost to £318 which is about £50 more …. wait thats a 3 litre pack I’ve been misreading…  2 more litres for £50 seems quite cheap right now.  What’s wrong with THIS listing?  Whatam I not seeing?