Reply To: Need Help Picking a 6mm Project

[phaidknott 7023xp 0]

Looking at cost (didn’t know 6mm were going to cost a fortune where you live, but then again Eureka are fleecing me for AB minis (so it works the other way too)). I wonder if these MDF 6mm might be worth a looksee

http://www.commission-figurines.co.uk/wp-content/uploads/2020/07/Commission-Catalogue-2020.pdf

I’ve used Irregular in the past, and they are ok”ish”. Problem for me has been in the past a lot of variance with the casts themselves (old molds pushed too far beyond their serviceable life perhaps). Some have been fine while others suffered from either bad slippage (all too easy to do with 6mm) or just plain rough casts making it hard to work out what is what on the figure.

 

Now imagine if Wofun could pantograph down their Naps range (or even better Naps with Mr Dennis’s artwork) down to 6mm/10mm. Now suddenly there would be something fantastic (and a lot lighter than metal minis).