Skip to toolbar
Collins Does Star Wars Legion

Collins Does Star Wars Legion

Supported by (Turn Off)

Vader and BabyVader have unresolved family issues

Tutoring 7
Skill 5
Idea 2
No Comments

So to finish off the models i painted the two leaders from the core set.

I started with Luke.

Most of his jumpsuit was painted with Celestra Grey, washed with a Lamian Medium diluted Nuln Oil and Athonian camoshade mix. Then highlighted with Celestra Grey again.

The skin was painted with Cadian Fleshtone, washed with Reikland Fleshtone then highlighted Cadian Fleshtone and Kislev Flesh.

the boots were painted Mechanicus Standard Grey and the washed Nuln then highlighted Mechanicus again.

The belt and holster were painted Mournfang Brown, washed Agrax Earthsafe then highlighted Mournfang again.

You’ll note that this is quite simple and easy, some may say lazy. And they’d be right, but I’m happy with this scheme and it didn’t take me too long to do either. win win for me i feel!

The lightsabre is the cool bit IMO. I painted it white so i had a fresh base to start with. I then made a super thin glaze out of Lahmian Medium and Baharoth Blue. This takes lot of mixing. I then (mentally) broke the lightsabre into 4 sections lengthways. I then painted the opposites the light blue glaze in very thin layers so that it gradually got stronger in the middle of the blue section.

When happy with the lightsabre i then went on to add blue glaze to the model and base to give a little object light source effect.

When the model had been varnished I put gloss varnish on the lightsabre to enhance the shiny bright special laser sword

After Pukey Lukey i painted Daddy Vader.

He was primed Black and then i tried to zenethal highlight him with spray cans… It turned out to be more work than it was worth. I wouldn’t be doing it again until i get an airbrush.

For the most part all the highlights were done before washing this time.

All these highlights were done using Russ Grey and the top highlights done with Fenrisian Grey.

The chest plate had a few colour put on it, compared to the movies and picked appropriate colours. Mostly red, green and grey.

Vaders lightsabre was done in the same fashion as Luke’s except i used Bloodletter Red Glaze. Including putting glaze on vader and the ground to make it look a bit like its giving off light.

When varnished I added Gloss Varnish to the sabre, helmet, shoulder armour and the shinpads.

Again, a simple scheme but i feel its effective. The light sabre is the focal point and takes a lot of the attention.

Supported by (Turn Off)

Leave a Reply

Supported by (Turn Off)