Skip to toolbar

Reply To: Help please!

Home Forums 3D Printing for Tabletop Gaming Help please! Reply To: Help please!

#1526438

redvers
21054xp
Cult of Games Member

To be honest, I have nothing to compare them with as to what is good or bad. I was expecting some ‘stepping’ and was planning to using some light filla to act as ‘render’. Otherwise, at 15mm scale, the imperfections aren’t that noticeable and hopefully a half decent paint job and some decoration as you suggest it should be good enough. I’ll post the results into the project I’ll fire up.

Supported by (Turn Off)