Skip to toolbar
3D Wolsung Terrain (spring cleaning challenge 2023)

3D Wolsung Terrain (spring cleaning challenge 2023)

Supported by (Turn Off)

Accident happen

Tutoring 4
Skill 4
Idea 4
No Comments

Last week i bump my gaming table a little to hard and topple my hanger wall and had one of them snap. I spent the rest of the week and weekend fixing the interior walls to be more stable. I decided to add some 1 cm magnets.

This print snapped at the lugs that where printed together as one peace.This print snapped at the lugs that where printed together as one peace.

I found some 1 cm x 1 mm round magnets which match a 3/8 drill bit i had.  I use the drill in reverse  to melt the PLA plastic  i used to print with.  Then i added some green stuff to fill and keep the magnet flush.

I created a test peace to keep all the magnet in a the right polarity. Then came the drilling, filling and testing.I created a test peace to keep all the magnet in a the right polarity. Then came the drilling, filling and testing.
Added these triangle feet to interior wall stable:).Added these triangle feet to interior wall stable:).

Supported by (Turn Off)

Leave a Reply

Supported by (Turn Off)