Create Your Own Tank With The MAV3RICK Modular Design From Treadhead Rad

November 23, 2018 by brennon

Supported by (Turn Off)

Treadhead Rad is on Kickstarter right now with a project to bring a Modular 3D Printable Tank Kit to the tabletop for use in 28mm wargames. Check out the MAV3RICK.

MAV3RICK - Modular 3D Printable Tank - Treadhead Red

The campaign is designed to not only get the files out there for you but also plenty of time for the creator to also test out the designs and make sure that you won't have any problems when it comes to printing this at home.

As mentioned, this is a project where you're going to be printing this tank for yourself at home so there's no chance to get yourself a physical copy of it via this fundraiser.

MAV3RICK - Modular 3D Printable Tank Options #1 - Treadhead Red

There are a lot of different options for the tank including a fully detail interior and then a range of weapons for both the top of the vehicle and the sides too with weapons all over the place. The focus has been on creating a kit which can be magnetised and tweaked each time you want to use it.

MAV3RICK - Modular 3D Printable Tank Options #2 - Treadhead Red

I think this is a neat idea and since the files are just delivered to you all you need to from that point onwards is simply just decide how many tanks you want. The design for the vehicle overall is nicely generic which means that it should fit into a whole bunch of different settings too.

This is a small project but the creator seems to be very active in the comments if you have questions about the campaign and the final product.

What do you make of the idea and design?

"The design for the vehicle overall is nicely generic which means that it should fit into a whole bunch of different settings..."

Supported by (Turn Off)

Supported by (Turn Off)

Supported by (Turn Off)

Related Categories