Burrows & Badgers - getting back to sculpting!

Supported by (Turn Off)

Project Entry by oathsworn

Getting dressed...

July 13, 2018

I started adding sleeves; they were very simply pressed into place, smoothed, and then some light creases and folds were marked in.

One important factor when sculpting a miniature for production is making it castable; and that means voids and undercuts should be avoided. There was a void between the lower part of the staff and the foot, so I decided to add a section of loincloth to fill it. I added some lumps of putty, blended them together with the Wax 5, then smoothed them with the Clay Shaper, and finally marked in some folds.

Next I added the lower sections of his robe; again, I added some lumps of putty, blended them together with the Wax 5, then smoothed them with the Clay Shaper, and finally marked in some folds, and marked in a few cuts and holes to make the robe look old and worn.